Fits:

-5Th Gen 4Runner

-GX460

What's included?

Basic Package- An O.E.M Vent, and our Proprietary Vent Cover pre-affixed ready to clip in. 

Complete Package- The basic package, plus the addition of our Activated Carbon Filter Module. This package is the ultimate protection against dust and smells. 

What is a Cabin Vent?  

 -Your vehicle has either 1 (3G4R, Sequoia) or 2 (all other models) Vents located in the quarter panel behind the rear bumper. These vents allow air to escape when shutting your door. Or when the blower motor is on, it provides a path for air to flow. This is crucial for air flow and to remove smells.

Without this vent, air is essentially trapped in the vehicle. Trapped air in the vehicle can be a hazardous situation if you have a leak in your exhaust up stream of the catalytic converter. or when shutting your doors it can cause your ears to pop from excess pressure. 

Why Do You Need our Vent Solution?

-After a few trips off-road or in a dusty environment in general. You will notice your rear cargo area has accumulated lots of dust, even though your A/C Controls were set to recirc. and your windows were rolled up the entire time.

This dust gets into your cabin through the vents in the quarter panel. Either from the vents breaking apart over time, or from the rubber flap not sealing properly. As your driving down the road, wind will make this flap move around and as this is happening your tires are kicking up all kinds of dust and debris straight into the vent. This applies to Vehicles with factory bumpers as well. But if your vehicle has any type of aftermarket bumper the coming into your cabin is even worse.

How Does Our vent differ from the factory vent?

-After analyzing the design, and how air acts around the vent, we based our design around the Venturi principle. By moving the Vent holes to the rear of the vent we have created a venturi effect to pull dust out of the vent as air is rushing past the vent holes. Having the cover installed on the vent even protects the flap from moving in the wind, so we prolonged the life of the flap and are ensuring the flap is sealing better than ever before.

The Basic Model includes - An O.E.M Vent with rubber flap, and we affix our 3D Printed Vent cover on to this vent. This option is ready to clip in once the factory vent/vents are removed

The Complete package includes - The basic model plus an additional protection measure, Our Activated Carbon Filter Module. This filter is a coarse Activated carbon filter material that is designed to trap 99% of the dust that gets past the cover and rubber flap. The activated carbon properties are also proven to trap smells such as skunk or other smells you might pick up from the road. 

What is our Vent Solution Made out of?

-We purchase the OEM vents directly from Toyota, all other parts are manufactured in house on our 3D Printers

We use only the best quality PETG filament with high dimensional accuracy. During our development phase we tested throughout the Summer in Phoenix AZ. and during the 120f days we found the 3D printed parts to have no visible or noticeable warpage or material degradation. 

Warranty?

- We offer a LIFETIME WARRANTY on all products we manufacture. this warranty is not applicable to the OEM vents that we purchase from toyota. 

If you experience a 3D printed part to fail, come unglued, or have layer adhesion issues we will replace the part no questions asked. 

This warranty does not apply if your Vent was crushed by boulder that you are trying to squeeze through and other similar situations.